FcallBox3 Remote Systeme

Detail :

Do not mount the Rasberry board in the box.

Power UP the box (a power supply 12V or a Freeplug (Freebox) must be connected on J1).

Power led must light ON

Verify the presence of a 5V voltage at the pins described below :

Power OFF the box, put the Raspberry with its SD card programmed in the box (see section Software).

Power UP the box, Power led must light ON

After several seconds, the STATUS led must light on if the option FCALLBOX3 remote Display has been activated (see section software).

At this step, the FCALLBOX remote box is ready to be used with the FCALLBOX3 remote system